call us on: +86-755-29196695  E-mail: info@pcba-assembly.com  
Shenzhen Rigao Electronics Co.,Ltd
Tel: +86-755-29196695
E-mail: info@pcba-assembly.com
Product Categories
Knowledge
Home > Factory Tour > Content

Work Level Type Description

Shenzhen Rigao Electronics Co.,Ltd | Updated: Jul 14, 2017

Work Level Type Description

   ⑴, signal layer (Signal Layers), there are 16 signal layer, TopLayer BottomLayer MidLayer1-14.

    ⑵, internal power / ground layer (Internal Planes), there are four power / ground layer Planel1-4.

    ⑶, mechanical layer (Mechanical Layers), there are four mechanical layer.

    ⑷, Drilling Layers (Drill Layers), mainly used for drawing drilling and drilling location, including Drill Guide and Drill drawing two layers.

    ⑸, Solder Mask (Solder Mask), TopSolderMask and BottomSolderMask two layers, hand on the tin.

    ⑹, Paste Mask (Paste Mask) TopPaste and BottomPaster two layers.

    ⑺, silk screen layer (Silkscreen), TopOverLayer and BottomOverLayer two layers, mainly used to draw the outline of the component outline.

    ⑻, other work level (Other):

    KeepOutLayer: prohibits the wiring layer, used to draw the printed board outside the border and positioning holes and other hollow parts.

    MultiLayer: Multilayer

    Connect: Connect layer

    DRCError: DRC error layer

    VisibleGrid: Visual grid layer

    Pad Holes: Pad Layers.

    Via Holes: Through Hole.

    16, PCB automatic wiring before the set

    ⑴Design | Rules ...

    ⑵Auto Route | Setup ...

    Lock All Pro-Route: Locks all pre-wired connections for automatic routing.


Contact Us
Address:Room601, YinDeFeng Building, No.7, AiMing Road, HouRui Community, XiXiang Subdistrict, Bao'An District ShenZhen 518128 China
Tel: +86-755-29196695  Fax:86-755-29196695
E-mail:info@pcba-assembly.com
Copyright © Shenzhen Rigao Electronics Co.,Ltd